UDP IPR535 GORIZONT PUSK

Manual start device IPR 535 Gorizont "Start" MK is designed to start the actuating mechanisms of fire extinguishing systems, smoke removal systems, etc. Explosion protection marking 1Ex d IIB T6 Gb. Full compliance with the requirements of GOST 53325 as amended in 2012.

The detector can be used as a single element, as well as in alarm loops (AL) for closing (parallel connection) or opening (series connection). Two-color status indicator: standby mode indication - green flashes with a period of 5-7 seconds; indication of the "alarm" mode - red flickering with a frequency of more than 5 Hz.

Class according to GOST 53325-2012: manual detector - class A (activation by one action); manual start devices - class B (activation by two actions).

Manual starter IPR 535 Gorizont "Start" is designed to start the actuating mechanisms of fire extinguishing systems, smoke removal systems, etc. The manual starter is designed for installation in hazardous areas of class 0 and below.

Name	IPR535 Horizon PUSK MK	IPR535 Horizon PUSK
Explosion protection marking	1Ex d IIB T6 Gb	0Ex ia IIB T6 Ga
Marking of microprotection parameters		LI: 1 µH, CI: 30 pF, UI: 27 V, II: 25 mA, PI: 0.8 W
Degree of protection of the shell	IP67	IP67
Operating temperature	-60°C<Ta<75°C	-60°C<Ta<70°C
Climatic performance	UHL1
Supply voltage	8-28V	8-28V
Current consumption in standby mode, no more	80uA	80uA
Own current consumption in the "Fire" mode, no more	0.7mA	0.7mA
Maximum current of the external additional resistor circuit, no more	100mA	100mA
Case color:	yellow	yellow
Housing material	Aluminium alloy	High impact polyamide
Dimensions without cable entries	131x122x46mm	134x108x46mm

Selection table for additional resistors

FACP type	Connection options
FACP type	Parallel connection (make)	Sequential connection (on opening)
LB-07	Rd must ensure current consumption> 15 mA,	Rd \u003d 11 kOhm, Rok \u003d 2 kOhm, VDok \u003d KD522.
LB-07	Rok \u003d 2 kOhm, VDok \u003d KD522.	Rd \u003d 11 kOhm, Rok \u003d 2 kOhm, VDok \u003d KD522.
Ray	Rd = 2.4 kOhm, Rok = 2.4 kOhm, VDok = KD521A.	Rd = 2.2 kOhm, Rok = 2.4 kOhm, VDok = KD521A.
PPK-2	Rd = 1.2 kOhm, Rok = 3.6 kOhm, VDok = KD521A.	Rd = 10.0 kOhm, Rok = 3.6 kOhm, VDok = KD521A.
fireball	Rd \u003d 1.5 kOhm (3.0 kOhm - to determine double drawdown),	Rd \u003d 8.2 kOhm (4.7 kOhm - to determine double drawdown),
fireball	Rok \u003d 4.7 kOhm, do not install VDok	Rok \u003d 4.7 kOhm, do not install VDok
Yakhont-16i	Rd \u003d 1.8 kOhm (4.0 kOhm - to determine double drawdown),	Not applicable
Yakhont-16i	Rok = 8.2 kOhm, do not set VDok	Not applicable
WERS	Rd \u003d 820 Ohm (1.8 kOhm - to determine double drawdown),	Rd \u003d 10 kOhm (4.7 kOhm - to determine double drawdown),
WERS	Rok = 7.5 kOhm, do not set VDok	Rok = 7.5 kOhm. Do not install VDoc

AM - indicates the presence of a product modification with an address label.

The IPR535 detector Horizont PUSK MK is supplied with cable glands of various designs:

for open laying of the attached cable (index in the designation - K );
for laying the attached cable in the pipe G1/2 ( T-1/2 );
for laying the attached cable in the pipe G3/4 ( T-3/4 );
for connecting an armored cable ( B );
for connecting a cable in a metal hose RZTSH-15mm or 20mm ( KM15, KM20 ).

The detector IPR535 Horizon PUSK is supplied with two cable glands, which allow the detector to be installed in an alarm loop with a round cable with a diameter of 6-10mm.

UDP IPR535 GORIZONT PUSK

Selection table for additional resistors

THIS SITE USES COOKIES