UDP IPR535 GORIZONT EMERGENCY EXIT

IPR 535 Horizon "Emergency exit" MK is designed to unblock emergency exits.Explosion protection marking 1Ex d IIB T6 Gb.

IPR 535 Horizon "Emergency exit" is designed to unblock emergency exits and is intended for installation in hazardous zones of class 0 and below.

	IPR535 Horizon EXIT MK	IPR535 Horizon EXIT
Explosion protection marking	1Ex d IIB T6 Gb	0Ex ia IIB T6 Ga
Marking of microprotection parameters		LI: 1 µH, CI: 30 pF, UI: 27 V, II: 25 mA, PI: 0.8 W
Degree of protection of the shell	IP67	IP67
Operating temperature	-60C<Ta<75C	-60C<Ta<70C
Climatic performance	UHL1
Supply voltage	8-28V	8-28V
Current consumption in standby mode, no more	80uA	80uA
Own current consumption in the "Fire" mode, no more	0.7mA	0.7mA
Maximum current of the external additional resistor circuit, no more	100mA	100mA
Case color:	green	green
Housing material	Aluminium alloy	High impact polyamide
Dimensions without cable entries	131x122x46mm	134x108x46mm

Selection table for additional resistors

FACP type	Connection options
FACP type	Parallel connection (make)	Sequential connection (on opening)
LB-07	Rd must ensure current consumption> 15 mA,	Rd \u003d 11 kOhm, Rok \u003d 2 kOhm, VDok \u003d KD522.
LB-07	Rok \u003d 2 kOhm, VDok \u003d KD522.	Rd \u003d 11 kOhm, Rok \u003d 2 kOhm, VDok \u003d KD522.
Ray	Rd = 2.4 kOhm, Rok = 2.4 kOhm, VDok = KD521A.	Rd = 2.2 kOhm, Rok = 2.4 kOhm, VDok = KD521A.
PPK-2	Rd = 1.2 kOhm, Rok = 3.6 kOhm, VDok = KD521A.	Rd = 10.0 kOhm, Rok = 3.6 kOhm, VDok = KD521A.
fireball	Rd \u003d 1.5 kOhm (3.0 kOhm - to determine double drawdown),	Rd \u003d 8.2 kOhm (4.7 kOhm - to determine double drawdown),
fireball	Rok \u003d 4.7 kOhm, do not install VDok	Rok \u003d 4.7 kOhm, do not install VDok
Yakhont-16i	Rd \u003d 1.8 kOhm (4.0 kOhm - to determine double drawdown),	Not applicable
Yakhont-16i	Rok = 8.2 kOhm, do not set VDok	Not applicable
WERS	Rd \u003d 820 Ohm (1.8 kOhm - to determine double drawdown),	Rd \u003d 10 kOhm (4.7 kOhm - to determine double drawdown),
WERS	Rok = 7.5 kOhm, do not set VDok	Rok = 7.5 kOhm. Do not install VDoc

AM - indicates the presence of a product modification with an address label.

The IPR535 detector Horizont PUSK MK is supplied with cable glands of various designs:

- for open laying of the attached cable (index in the designation - K );
- for laying the attached cable in the pipe G1/2 ( T-1/2 );
- for laying the attached cable in the pipe G3/4 ( T-3/4 );
- for connecting an armored cable ( B );
- for connecting a cable in a metal hose RZTSH-15mm or 20mm ( KM15, KM20 ).

The detector IPR535 Horizon PUSK is supplied with two cable glands, which allow the detector to be installed in an alarm loop with a round cable with a diameter of 6-10mm.

UDP IPR535 GORIZONT EMERGENCY EXIT

Selection table for additional resistors

THIS SITE USES COOKIES